It is currently Sun Sep 24, 2017 9:23 pm

  • Album
    Images
    Last Image

Recent comments

Comment by GORDON.LAPLANTE » Sat May 07, 2016 8:40 am

Its all about bed adhesion. When printing large flat areas the plastic sometimes has a hard time adhering to the bed and instead it will curl up. This will cause the wavy line pattern. Are you printing on acrylic? It may take some testing but you might need to dial in the right slicing settings to get it just right. Try printing the first layer at 50% width and around 150% layer height. Also slow down the first layer. You will see on the corners (where the travel distance is shorter) it has no problem sticking and its usually in the large open spaces.
Comment on:
print
print
 
Uploaded by MikeTee
Wed May 04, 2016 3:07 pm

Comment by shaqFoo » Fri Aug 14, 2015 1:27 am

Can't wait to see supersized ditto prints!

viewtopic.php?f=6&t=518 :D
Comment on:
gMax Dual, Single Extrude...
gMax Dual, Single Extruders From the Back
 
Uploaded by GORDON.LAPLANTE
Thu Aug 13, 2015 6:37 pm

Comment by shaqFoo » Fri Aug 14, 2015 1:25 am

Yeah, arbitrary offsets for ditto printing. That sounds familiar.

viewtopic.php?f=6&t=518
Comment on:
How To Increase Print Out...
How To Increase Print Output?
 
Uploaded by GORDON.LAPLANTE
Thu Aug 13, 2015 6:37 pm

Comment by shaqFoo » Fri Aug 14, 2015 1:14 am

Yeah, arbitrary/adjustable offsets for ditto printing and dual extrusion.

Sounds familiar.....

viewtopic.php?f=6&t=518
Comment on:
gMax Dual Single x-axis P...
gMax Dual Single x-axis Plates
 
Uploaded by GORDON.LAPLANTE
Thu Aug 13, 2015 6:37 pm

Comment by crussell » Thu Aug 13, 2015 6:54 pm

Mama always said 2 heads were better than one!
Comment on:
How To Increase Print Out...
How To Increase Print Output?
 
Uploaded by GORDON.LAPLANTE
Thu Aug 13, 2015 6:37 pm

Login  •  Register

Who is online

In total there is 1 user online :: 0 registered, 0 hidden and 1 guest (based on users active over the past 5 minutes)
Most users ever online was 217 on Sun Jan 11, 2015 9:19 am

Registered users: No registered users
Legend: Administrators, Global moderators

Statistics

Total images 27 • Total comments 6