Hello all,
I'm getting this issue where the side walls of parts are not smooth vertical surfaces, but they have ripples or bands of different widths. I've tried messing with extrusion multiplier, speed, layer height, temperature, lead screw tightness, and fan speed. Any idea how to fix this? The rods seem very straight, and the couplers appear to be doing their job. My next attempt was going to be trying new filament, and then tightening belts some more (but they already are around the tightness of my cr-10 and flashforge belt tightness).
I have the newer type gMax 1.5XT+ with the dual E3D extruder, and the BLTouch sensor. I do not have the heated bed installed. Several models have been tried with various parameters in Cura, and the stock files from the SD card shipped. The image shown is of the g keychain model on the SD card.
Thank you,
--
Andrew
I'm getting this issue where the side walls of parts are not smooth vertical surfaces, but they have ripples or bands of different widths. I've tried messing with extrusion multiplier, speed, layer height, temperature, lead screw tightness, and fan speed. Any idea how to fix this? The rods seem very straight, and the couplers appear to be doing their job. My next attempt was going to be trying new filament, and then tightening belts some more (but they already are around the tightness of my cr-10 and flashforge belt tightness).
I have the newer type gMax 1.5XT+ with the dual E3D extruder, and the BLTouch sensor. I do not have the heated bed installed. Several models have been tried with various parameters in Cura, and the stock files from the SD card shipped. The image shown is of the g keychain model on the SD card.
Thank you,
--
Andrew