I turned down the extrude temperature to 230C that kept the Max Temperature error away but now it seems like it may not be hot enough because the filament gets stuck in the nozzle and that messes uo the entire print.
PEI (ULTEM) is expensive, I'm looking into getting the glass heated bed.
You mentioned ABS, is that the filament your talking about, and I'm not sure what won't stick, seems like I want it to stick.
I'll check out Printinz too.
Simplify3D works great!! Thanks for the advice. It would be nice to see a detailed explanation for what all of the setting mean but for now its working great.
I have one unrelated problem, a couple of corners are lifting. I have just put on new blue tape and was able to watch the first several...