Recent content by jashmow1

  1. J

    MINTEMP error?

    Hi, The temp sender just quit while I stepped out of the room for about 5 minutes. I came back in and the printer hot end was sitting on the printer table. It looks like the white part of the printer head melted and the hot end was sitting on the the table still connected. I turned...
  2. J

    Operation Instructions

    Hi G, That config worked! Printing is really close I printed at 225C and it looks to be a bit hot. I will do some more testing. I had a little curling on the base. Might be the room temp. I will try it with room temp at 72 and turn the printer temp down to 220C and see. THANK YOU SIR...
  3. J

    SD card help...

    Hi G, Thank you for your posting! The environment here is dryer and about 64 degrees with low static. The wires connected incorrectly were the D9 block on the board... they were reversed. As for the SD card. I am using the slot on my Laptop as the slic3r program is a little easier to...
  4. J

    Stringy looking printed objects.

  5. J

    SD card help...

  6. J

    Printing Q