Recent content by jBrouwers

  1. J

    PLA not sticking

    Hi Chris I've set the first layer to 230 and the rest to 207. The bed and nozzle are set very nicely and leaves little room in between. The first layer is not squishing down onto / into the bed (had that before and indeed ruined one side of the acrylic bed) so in my experience so far, that went...
  2. J

    PLA not sticking

    230 start seems to work a whole lot better. Thanks!
  3. J

    PLA not sticking

  4. J

    new config / firmware files

    thanks mwu, I'll try that,
  5. J

    X-axis stepper motor

    I fixed it. I think that due to calibration, the wire was just too tight
  6. J

    X-axis stepper motor