Hello Joshua, I was wondering where I could get a copy of Marlin 1.1.9 for my gMax2. I'm changing to the TMC-2208 stepper drivers. I figure it will be a lot easier to configure using The gMax 2 stock firmware rather than a stock marlin.
Hello, I am new to 3D printing and went all out an bought the gMax 2. I finished a Pika-Pool print today and noticed the Z axis was making a weird noise when it traveled down. I am not sure if it was a motor losing step. I figured out that the X-axis was not level. I tried the onboard Level X...