I know this is an old thread but thought I would add my two cents, one of the things I do is I apply blue painters tape (the 3m stuff that has a tad bit of roughness to the outside) and apply a generous amount of hairspray to the build platform. which makes the parts stick real well especially...
Got an issue that has arisen since the install of Marlin 1.1.8 and after exhaustive research and experimentation I have narrowed down the cause of my printer suddenly shifting layers in the middle of long prints. this seems to only affect prints when using a heavier table platform such as a...
So today I had a print that was about 12 hours into the print and had to do a filament change. I went into the menu and selected change filament and it took a few seconds and then when to the change position and unloaded the filament, then the message changed and said heating it was heating the...