Recent content by MBuch08

  1. M

    MINTEMP error?

    I attempted to clean the thermistor as well as check that both connections are solid and I'm still getting the same reading. I was wondering what it takes to get the new parts with soldered connections to reduce the chances of running into this problem again. Many Thanks
  2. M

    MINTEMP error?

    Thanks for the input thus far. I was wondering how at-risk other components will be if I attempt to take apart the electronics box and metal extruder. Also, how do I determine if the thermistor is damaged and how should I proceed if it is? Many thanks.
  3. M

    MINTEMP error?

  4. M

    Heated Platen

    The hotter the base layer is -> the more adhesive it should be? Would it be a bad idea to increase the temperature of the first couple layers if some of them are very minimal in surface area? Having some problems, a little bit with edge curling up on some gear edges i'm attemping to print...
  5. M

    Pushing my boundaries