Print centering.

[bikeslider]

My prints start off center of the build plate. X-25mm, Y-5mm off center. Using ultimaker cura 3.2.1 with gmax 1.5 dual extruder configuration downloaded from g-create. How do I get prints to start in center. As is I can not utilize the full bed size for prints. Bed setting is x406 y406 z533. unchecked origine at center and heated bed.

 

[gCreate_Joshua]

Try adding a "M206 x50" to your start gcode. That should get the first nozzle printing in the center of the bed. I used the value of 50 because 2 in = 50.8mm. If this shifts it the wrong direction just try x-50.