Hi guys. I’m hoping you might be able to help me figure out what’s going on with my gMax 2 dual nozzle printer.
Every time I try to print with dual heads the printer hangs up after a few layers. It just stops printing. A little bit after it sits there it comes up with a message on the LCDSaying that it’s going to do a filament change on E2. It doesn’t Happen if I only use one extruder. I’ve looked at the gcode and it looks OK to me. I’m including both The gcode file and a small video of it happening. I have tried with Cura, S3D and Ideamaker. Same results. Also tried octopi and direct from computer
Every time I try to print with dual heads the printer hangs up after a few layers. It just stops printing. A little bit after it sits there it comes up with a message on the LCDSaying that it’s going to do a filament change on E2. It doesn’t Happen if I only use one extruder. I’ve looked at the gcode and it looks OK to me. I’m including both The gcode file and a small video of it happening. I have tried with Cura, S3D and Ideamaker. Same results. Also tried octopi and direct from computer
Attachments
-
4.1 MB Views: 2
-
14.6 MB Views: 7