Search results

  1. K

    Looking for 1.0 manual, firmware, config, etc.

    Today: Manual control from the LCD still works. Computer control no joy. Connecting... start Printer is now online. echo: External Reset gMax Marlin 1.0.0 echo: Last Updated: Jul 12 201612/23/201419:53:33 | Author: Gordon LaPlante (Gordon LaPlante, gMax 1.5 Configuration) Compiled: Jul 12...
  2. K

    Looking for 1.0 manual, firmware, config, etc.

    So, the 1.0 manual, wiring diagram, firmware and config files are just gone? Somebody must have a copy, right? XYZ axes all function correctly, X and Z home correctly, Y doesn't home at all, and I have a mintemp error. Things are not going well. Is the 1.0 a dead platform now?
  3. K

    Looking for 1.0 manual, firmware, config, etc.

    Everything seems to be seated correctly, and all the endstops operate. If I jog the bed into the y endstop, the switch works, the light comes on and the bed stops. I've tried home y in pronterface and simplify, and sending the gcode command manually. For some reason the board isn't receiving...
  4. K

    Looking for 1.0 manual, firmware, config, etc.

    One last minor success, got simplify to talk to the printer. Baud rate needed to be set to 250000. But no Y-homing there either. :-/
  5. K

    Looking for 1.0 manual, firmware, config, etc.

    I got the X, Y and Z all moving in the right direction. Yay! But the Y home command doesn't do anything. Home all axes does X and Z, but also doesn't home Y. I found a loose white wire at the printer cable end of the board, reattached it, but that goes to the printhead, and in any event...
  6. K

    Looking for 1.0 manual, firmware, config, etc.

    Hmm. Tried to reverse y axis in the configuration.h, but whatever I did didn't work, the bed homed in the wrong direction, which I kind of expected and pulled the plug before it hit anything. So I undid what I did to configuration.h, reuploaded the firmware, and reversed the plug from the y...
  7. K

    Looking for 1.0 manual, firmware, config, etc.

    Well halleluhah or whatever. Pronterface talks to the printer. Makes it move and everything. w00t! Still taking any tips or recommendations, especially any specific to 1.0 thx
  8. K

    Extruder won't feed filament

    OK, got the filament through, must be a lip in there somewhere.
  9. K

    Controling jerk and setting stepper motors

    Whoops, there it is. Don't know how I missed it. Thanks!
  10. K

    Controling jerk and setting stepper motors

    I just (mostly) finished my build. At first I was having erratic choppy motion on the Y axis. I tried to adjust the pot but didn't have any luck. I swapped the stepper controller as you suggested and now everything is working well. However, while pulling and swapping the stepper controllers...