Search results

Im getting an error saying "firmware cannot be uploaded because there is no connection with the printer". I just replaced all the boards. I was geting this error before the board replacement. Suggestions...

My other issue is the bl touch leveler is not doing anything when I turn the gmax controller on. Are all these components compatible? Do you turn the gmax controller on first before the Gtouch?

Here are my questions: 1. I can get my Gtouch to talk to the 1.5+ controller- Move the extruder xyz but if I try to preheat the head, they disconnect from each other. I have tried all the baud rates and it only works at 250 somewhat. I have a USB cable plugged into the upper left USB port of the...