Search results

On my gMax 2.0 I was having issues with the X axis shifting. Typically it would not happen until a few hours into the print. I started by cleaning all the ways and replacing the bearings in the carriage but it just kept getting worse. I looked all around and could not locate anything that the...

Sounds good, thanks for the update.

The gmax 2 was pre-ordered quite a while ago and was received over the weekend. I'm also wondering what is going on with the heated beds included in the presale? Ours was not included and I haven't seen anything about when they could be expected.

Just an FYI, I was having issues with the wires going to the limit switch getting very hot, and my x-axis motor was getting stray voltage causing it to stutter every few seconds. After a little troubleshooting it was discovered that my filament run out sensor was wired up backwards. Once I...