Search results

  1. E

    G-max 2 filament run out sensor wired wrong

    Sounds good, thanks for the update.
  2. E

    G-max 2 filament run out sensor wired wrong

    The gmax 2 was pre-ordered quite a while ago and was received over the weekend. I'm also wondering what is going on with the heated beds included in the presale? Ours was not included and I haven't seen anything about when they could be expected.
  3. E

    G-max 2 filament run out sensor wired wrong

    Just an FYI, I was having issues with the wires going to the limit switch getting very hot, and my x-axis motor was getting stray voltage causing it to stutter every few seconds. After a little troubleshooting it was discovered that my filament run out sensor was wired up backwards. Once I...