Search results

  1. B

    z axis start print too low

    Recently updated firmware using cura. Now prints start too low. Printer auto home and bed level good. When the print begins the printer starts the first layer 8mm too low. This is pushing the bed down. Then I have to z correct up 8mm. cura start menu G21 ;metric values G90 ;absolute...
  2. B

    Print starting too low.

    Recently updated firmware using cura. Now prints start too low. Printer auto home and bed level good. When the print begins the printer starts the first layer 8mm too low. This is pushing the bed down. Then I have to z correct up 8mm. cura start menu G21 ;metric values G90 ;absolute...
  3. B

    Print centering.

    My prints start off center of the build plate. X-25mm, Y-5mm off center. Using ultimaker cura 3.2.1 with gmax 1.5 dual extruder configuration downloaded from g-create. How do I get prints to start in center. As is I can not utilize the full bed size for prints. Bed setting is x406 y406 z533...