Search results

I have upgraded from 1.5 to 1.5+ duel extruder with TMC 2130 drivers on the X and Y steppers. I have been having problems with the control bored (like blue smoke) and I was wandering if the original 1.5 power supply is not sufficient enough for the Gmax 1.5+ system.

After my G-max 1.5+ preforms the bed height probe test after selecting the print from SD card it will start the first moments by moving up and then moving down to start the printing, but when it makes that first move up is will stutter. When it moves down to stat the print the system thinks it...

I have upgraded my Gmax 1.5 to the 1.5+ and I have everything running fine but when it's prints the Y axis dose not move up properly and the print just pouts more material in the last layer. It dose move up but just not to what it needs. I have looked at the power to the motor and this is not...