Search results

  1. L

    Print stuck to acrylic bed.

    I know this is an old thread but thought I would add my two cents, one of the things I do is I apply blue painters tape (the 3m stuff that has a tad bit of roughness to the outside) and apply a generous amount of hairspray to the build platform. which makes the parts stick real well especially...
  2. L

    Rapid Y Axis Layer Shifting on large prints

    Got an issue that has arisen since the install of Marlin 1.1.8 and after exhaustive research and experimentation I have narrowed down the cause of my printer suddenly shifting layers in the middle of long prints. this seems to only affect prints when using a heavier table platform such as a...
  3. L

    Change filament issue

    So today I had a print that was about 12 hours into the print and had to do a filament change. I went into the menu and selected change filament and it took a few seconds and then when to the change position and unloaded the filament, then the message changed and said heating it was heating the...