Search results

I've experienced this issue on my last two prints, and I have yet to figure out a solution. For reference, the print has roughly a 40 hr run time so i'm setting it up in the morning and monitoring it throughout the workday. The printing done while I'm there has been better than expected, which...

Thanks for the advice. I recently purchased a PEI sheet, but was hesitant to install it thinking it would actually compound the issue. I was not aware that the bed leveling was not being saved. I'll remove the startup routine and see if that helps.

I've been having adhesion issues with my first layers recently, which based on some trial and error seems to be due to the bed not being level. I'm using the gMax 1.5+ that has the BLTouch auto-leveling sensor, which from what I understand removes the need to manually level the bed. However...