I had this sci-fi egg I did for a project in Cinema4d and decided to print it. This was the first time I printed something that needed support material. I used slicer's basic settings to set the loft material. It turned out very cool looking. I treated it with a little acetone using my Makeraser.
The egg sort of resembles a butterfly egg and hornets nest. A neat little desk display.
After removal of the support material:
After being cleaned up with acetone:
The egg sort of resembles a butterfly egg and hornets nest. A neat little desk display.
After removal of the support material:
After being cleaned up with acetone:
Attachments
-
97.1 KB Views: 2,534
-
142.5 KB Views: 2,534
-
140.4 KB Views: 2,534