Slowly getting better at dialing in the printer. One question i have, why the change in design on the bed. I noticed in previous pictures during the kickstarter phase that the bed was mounted totally different than now. I have dialed the accel setting clear down to 2000 (default 9000) helped out big time. The rapid movements were to much at 9000 to keep the bed in place. There is to much freedom with the bed being mounted on springs. Nothing worse than getting up in the middle of the night on a 10 hour print to find out the bed has moved now the print is off. Even at slower feed rate the accel default is to high. Looking at redesigning the bed mount to get rid of the play allowed by the springs. Gordon, i would like to hear your feedback as to why you went with the style now verse the previous style you had. Also suggestions on settings you are running now to keep your bed from moving.