It took around 9 hours to assemble everything up to the point when I first turned it on. After that you will need some time to figure out how to operate it. I used t-nut STL file from gMax parts to set everything up. It prints in about 9 minutes so it takes fairly short amount of time to see end results.
Here are few things I have encountered (in no particular order) while assembling my gMax:
Here are few things I have encountered (in no particular order) while assembling my gMax:
Attachments
-
185.9 KB Views: 3,762
-
164.9 KB Views: 3,762
-
163.3 KB Views: 3,762