Hello All,
My filament is being pushed off the swing arm bearing by the drive gear. This causes the filament to be pinched, and break or it just does not feed.
My thoughts were to find a v-groove/flange bearing to make sure the filament stays on track, but I wanted to see if anyone else had easier solutions or something I should be doing.
Thank you in advance for your help!
My filament is being pushed off the swing arm bearing by the drive gear. This causes the filament to be pinched, and break or it just does not feed.
My thoughts were to find a v-groove/flange bearing to make sure the filament stays on track, but I wanted to see if anyone else had easier solutions or something I should be doing.
Thank you in advance for your help!