Filament Run Out Sensor Questions

[refriedchicken]

1.) Has the firmware been updated so I can run two on my dual extrusion system?

2.) I am having issues with "glossy" filament not being detected. Is there a way to adjust the sensitivity or handle these filament types?

 

[refriedchicken]

OK so I answered number two after looking at the sensor more, it is not optical. So I just bent the switch to protude further and problem solved. But still wondering about the dual extrusion.

 

[Jarhead]

Just wire them in series to the same pins.
You don't care which one runs out, if either does you want the print to pause.

 

[refriedchicken]

Cool, I was hoping that was the case if the software wasn't up to it.