gMax 2 Z-Axis Noise

#1
Hello, I am new to 3D printing and went all out an bought the gMax 2. I finished a Pika-Pool print today and noticed the Z axis was making a weird noise when it traveled down. I am not sure if it was a motor losing step. I figured out that the X-axis was not level. I tried the onboard Level X axis tool, but this did not fix the issue. I assumed that it was tweaked a little too much for the tool to fix. An easy fix for this to simply place a small level on the LED light bracket and spin the lead screw on either side until it shows level. The screw is will feel a little tight when it is level. After doing this I moved the Z axis up and down again and the sound was gone. I hope this helps someone. 20190617_230321.jpg 20190617_230327.jpg 20190617_230334.jpg 20190617_230343.jpg 20190617_230348.jpg
 

Attachments