today i printed the white parts in the 2 photos attached. very similar grey parts were printed on an Ultimaker Original Plus with PLA a few weeks ago.
why are my parts so bad? i used most slic3r settings from the config file entered into cura and oriented it in an isometric type position (the grey parts were printed in an iso position, but i don't know if they were printed at same time or same exact orientation).
what am i doing wrong? waiting almost 3hrs for this print was not what i was hoping for...
why are my parts so bad? i used most slic3r settings from the config file entered into cura and oriented it in an isometric type position (the grey parts were printed in an iso position, but i don't know if they were printed at same time or same exact orientation).
what am i doing wrong? waiting almost 3hrs for this print was not what i was hoping for...
Attachments
-
951.9 KB Views: 2,323
-
928.3 KB Views: 2,322