Installing Y-axis Plate

gCreate_Joshua

Administrator
Staff member
#1
Installing Y-axis Plate

The Y-Axis metal plate installation is a fairly easy process and the belts supplied are long enough to allow for future tightening. Use the guide below to install a new Y-axis plate or belt.


Loop.JPG
Insert the GT2 belt in the top hole of the metal plate with ribbed side down.

Then loop belt through lower hole as shown.



ziptiecut.JPG
Using the supplied zip-ties, wrap them around the the overlapping pieces of gt2 belt and pull tight.

Once tight, trim the ends of the zip ties.





pully install.JPG
Y-axisMotor.JPG
Install belt on gMax frame through rear pulley and front motor.




excessBelt.JPG
Once belt has been run through rear pulley and motor bracket, insert belt into lower slot of the metal plate. Pull excess belt up towards top of bracket.




tightenm5.JPG
While pulling the belt tight, use the 2 M5x10mm low profile screws and double tnut to secure belt in place.




loopedExcess2.JPG yaxisplate_wrapped.JPG
Insert remaining belt into vertical slot on metal plate. To tighten the belt in the future, simply loosed the double tnut and pull belt tight.




Installing Y-axis Plate on the Printer

printer tilt.JPG
PlateAttached.JPG
Once the plate is installed, reinstall the aluminum bed and tilt the printer back. You can support the top of the printer with an old filament box. Attach the Y-axis plate to the aluminum bed with the (2) M5x10mm low profile bolts and the tnuts that should be installed on the aluminum bed frame.
 
Last edited: