The install instructions for 1.1.9 state G29 should be removed from the start gcode. This prevents the bed probe from running before each print. Marlin documentation indicates G28 disables bed leveling and we need M420 S1 after G28 to reenable bed leveling or RESTORE_LEVELING_AFTER_G28 needs to uncommented in configuration.g before uploading the firmware.
RESTORE_LEVELING_AFTER_G28 is still commented in the Marlin zip from the downloads section. Is bed leveling being turned on some other way or are we running without it in gCreate's 1.1.9 release.
RESTORE_LEVELING_AFTER_G28 is still commented in the Marlin zip from the downloads section. Is bed leveling being turned on some other way or are we running without it in gCreate's 1.1.9 release.