I'm wondering a few things about Marlin, I'll try to list them in detail below. For the record I am currently using a gMax 1.5+ printer with dual E3D extrusion, PLA main with soluble PVA support, heated bed, using Cura versions 3.2.1, 3.6, and 4.2 (for experimentation purposes), and I'm using Marlin 1.1.1 as my current firmware version (because it was detailed in the dual extrusion upgrade instructions to install Marlin 1.1.1 - I was using 1.1.8 before with a single J-Head)
NOTE: Somehow my post was not approved by moderators, maybe it timed out IDK. Certainly no forum staff have been active on here for some time, and I didn't post anything offensive or bad that would cause it to be rejected. So to keep the length shorter, I'll be asking my questions in the comments below.
NOTE: Somehow my post was not approved by moderators, maybe it timed out IDK. Certainly no forum staff have been active on here for some time, and I didn't post anything offensive or bad that would cause it to be rejected. So to keep the length shorter, I'll be asking my questions in the comments below.