New gMax 1.5+ Dual E3D Extruder with BLTouch

[Blooper]

Hello Everyone,

I just purchased the 1.5+ Dual E3D Extruder with BLTouch and I need a little help. I could not find instructions on where to actually plug in the BLTouch and also I noticed that the newest Marlin firmware was for a Full Graphic Display....
Thank you in advance.

Does this count as a Full Graphic Display?

 

[gCreate_Joshua]

This is not the full graphic display. https://shop.gcreate.com/products/laser-cut-metal-lcd-screen-full-graphic-display is where you can find out more information on the full graphic display. It will still work with your blue electronics, you would just have swap out the LCD shield on them with the red one that would come with the display.

 

[Blooper]

Hmm ok awesome and thank you. I'd be able to take advantage of the newest Marlin firmware then? Also are there instructions on where to plug in the BL Touch wiring?

 

[gCreate_Joshua]

You certainly can use the new firmware.. Shoot an email to support@gcreate.com and I can help you out with wiring diagrams and such.