This a few simple question... so here goes.
1. When my printer goes to print it goes to the other end of the print table and starts to print. The issue is it goes past the etched area on the print bed. Does anyone had some info on setting up the table of print area?
I figured this one out, The stops side a bit on the bars. I had to really tighten things down more then I thought the plastic could hole... That resolved this iisse
2. Cleaning my screw-ups. Print bed is a bit litter with things I started to print but has to shut down as the print head was going to come in contact with the bolts that hold the bed on. As the result of this there is bit of dried PLA stuck to the printer bed. Thoughts on cleaning?
I figured this one out, The little scraper is not pulling the litter up... looks pretty stuck to the printer bed.put olive oil on the bed and 8 hours later I tried and the PLA came off with a little force. A thin layer of olive oil on th bed keeps things from getting stuck on the bed.
1. When my printer goes to print it goes to the other end of the print table and starts to print. The issue is it goes past the etched area on the print bed. Does anyone had some info on setting up the table of print area?
I figured this one out, The stops side a bit on the bars. I had to really tighten things down more then I thought the plastic could hole... That resolved this iisse
2. Cleaning my screw-ups. Print bed is a bit litter with things I started to print but has to shut down as the print head was going to come in contact with the bolts that hold the bed on. As the result of this there is bit of dried PLA stuck to the printer bed. Thoughts on cleaning?
I figured this one out, The little scraper is not pulling the litter up... looks pretty stuck to the printer bed.put olive oil on the bed and 8 hours later I tried and the PLA came off with a little force. A thin layer of olive oil on th bed keeps things from getting stuck on the bed.