Hey Joshua, I created a thread on the gmax forum but it hasn't got a reply yet. I also sent you a message, but it appears to have not gone through? I sent an email to gCreate but haven't got a reply yet on that one either so... here I am again haha. Just looking for some help, your guide on upgrading to a dual extruder only shows what to do when you replace the head, whereas my dual upgrade is the entire unit. Etc.
Hello Joshua, I was wondering where I could get a copy of Marlin 1.1.9 for my gMax2. I'm changing to the TMC-2208 stepper drivers. I figure it will be a lot easier to configure using The gMax 2 stock firmware rather than a stock marlin.
The heat sinks that came on my printer were attached with foam tape! The drivers actually worked better with the heat sinks removed. The foam tape actually insulates the driver keeping it warmer. I ordered new heat sinks and after installing everything is great. If you press on the heat sink and can see it get closer to the board you probably have foam tape.
Hi Joshua, I read you're the guy to talk to about printer issues. I am having troubles in that a couple of my designs won't print. The printer is moving along the design as it should, but the drive gear that pushes the filament through the hotend is not turning. When I try to print an older design it works great, just the 2 designs I did today won't allow for the gear to turn. I assume it is something with the file.
I am looking to replace my E3D nozzle with a larger one for quicker printing times, but I see conflicting information on the website. What is the largest I can go with my 1.5xt+ printer? Thank you
Fairly new to 3D printing, and am currently using Cura. I am trying to align two models for a dual extrusion. YouTube videos all show it easily being done using cura and the Ultimaker. After following the steps in the videos, and assigning each model to a printer head and hit merge, it aligns the two models side by side instead of on top of each other. Has anyone figured this out?
I did upgrade my GMax1.0 to Gcreate 1.5/1.5+ but the Y-Axis always made a noise when it hit Y-end stop. It looked like Y-axis still wanted to go further.
I did check the belt tension, it's fine.
Can you help to solve this issue please?