Print speeds/extrusion multipler for better finishes

Check here for useful tips on how to get your printer to print at its best.

Print speeds/extrusion multipler for better finishes

Postby Jman » Thu May 14, 2015 4:10 pm

I have looked at the Gcreate part 1 video a few times and noticed that the stock settings that I got on the Slic3r config download and what Gordon has on the screen were different on the print tab under speed. I looked around online and also found that people play with the extrusion multiplier setting as well to get better quality prints.

Do any of the people that have had the Gmax for a while have optimized/better settings for high/medium/medium fast printing?
These users thanked the author Jman for the post (total 0):
Jesper Ingerslev
Director of Engineering
Factory Five Racing
User avatar
Jman
 
Posts: 25
Joined: Fri May 08, 2015 8:30 am
Location: Wareham, Massachusetts
Has thanked: 0 time
Been thanked: 0 time

Re: Print speeds/extrusion multipler for better finishes

Postby gCreate_Kyle » Thu May 14, 2015 5:49 pm

Its determined by your desired quality vs speed and the features of the part your'e printing. The current slic3r settings are a very good starting point. That is what you should use. I use them almost 95% of my prints.

The settings you saw in the tutorial may have been leftover settings for a specific model in a specific situation. It may not have even been a stock gMax. He plays with many different hardware setups.
These users thanked the author gCreate_Kyle for the post (total 0):
R. Kyle Gress
gMax Technical Support
3D Printing/Electronics Enthusiast
User avatar
gCreate_Kyle
 
Posts: 169
Joined: Mon Feb 02, 2015 8:47 am
Location: Lancaster, Pennsylvania
Has thanked: 11 times
Been thanked: 18 times


Return to gMax Tips and Tricks

Who is online

Users browsing this forum: No registered users and 2 guests