Slicer Profiles

Check here for useful tips on how to get your printer to print at its best.

Slicer Profiles

Postby Levitate » Wed Mar 19, 2014 11:06 pm

Thanks for the slicer profile that you have posted on the download section! I was wondering if there is any possibility to post the profiles you have Gordon for the awesome high resolution prints that are pictured online. I appreciate the starting point but would really like to print in higher resolution like .075mm and lower layer heights. I am a novice at slicer and really not had any luck with adjusting the resolution. If this is not possible from the 0.5mm nozzle than what is the highest resolution that nozzle can use?

Thanks Levitate
These users thanked the author Levitate for the post (total 0):
User avatar
Levitate
 
Posts: 16
Joined: Tue Mar 18, 2014 12:31 am
Has thanked: 0 time
Been thanked: 1 time

Re: Slicer Profiles

Postby raykholo » Thu Mar 20, 2014 11:37 am

In the Slicer tab of Repetier, there is a text box to manually enter the layer height of your choosing. Then just slice again and print.
These users thanked the author raykholo for the post (total 0):
Ray Kholodovsky
Owner | Cohesion3D
Cohesion3D.com
raykholo
 
Posts: 213
Joined: Mon Jan 13, 2014 6:19 pm
Has thanked: 0 time
Been thanked: 1 time

Re: Slicer Profiles

Postby Levitate » Thu Mar 20, 2014 10:07 pm

Yeah I was afraid it was that easy. I tried that already and I found out my Z was not repeating. Printed out the new Z limit switch mount (thanks Gordon) and during the install noticed the switch was damaged. Just waiting on replacement now.

Thanks Raykholo
These users thanked the author Levitate for the post (total 0):
User avatar
Levitate
 
Posts: 16
Joined: Tue Mar 18, 2014 12:31 am
Has thanked: 0 time
Been thanked: 1 time


Return to gMax Tips and Tricks

Who is online

Users browsing this forum: No registered users and 1 guest