Unable to access parts files

While you could print the brackets, I recommend you get a couple of aluminum ones from 80/20 which is what the 1.5 uses. This is what you need: http://www.amazon.com/80-20-4-HOLE-INSI ... ket+4+hole

The aluminum ones will afford you more rigidity than a printed one. If you would rather print it out, I've attached the stl file I downloaded when I started planning my build before the 1.5 was announced.

Thanks MWU.

I'll look into the aluminum brackets when I can buy the t-slot rails and all the rods for the XL upgrade. For now the brackets in PLA at 30-40% infill should be sturdy enough.

We've fixed the problem with the download section. It should work fine now.