Simple Newby Question

#1
Hopefully a simple question for those GMAx pros out there. New GMAx 1.5 xt + out of the box. Have attempted several prints and continuously get an error message that says "end stop hit z" or something to that effect.

Any suggestions ?

Thanks
 

Roxy

New Member
#2
Do you have a BL-Touch probe on it? If so... Are you seeing the red error light on the probe? Because if you are seeing the error light, BL-Touch probes return a 'Triggered' status while in an error state. If that is happening, you need to work to get the BL-Touch not to be in an error state.