Just upgraded from a dual nozzle J end to the E3d hotend. Updated the firmware as instructed. As far as i can tell, Machine's running okay except that i can't get the feed to work. Doesn't feed to print and it won't feed if i try to run the Purge sub.
Heating/main cooling fan/BL Touch all seem to be operating as normal (as far as i can tell), just the feed servo. (i haven't seen the continuous cooling fan run yet either, but i haven't run a full test with this feed issue).
As far as i can tell, i've hooked everything up alright (it was pre-built when i got it for the most part). Maybe a firmware setting i've missed?
many thanks for any help.
Heating/main cooling fan/BL Touch all seem to be operating as normal (as far as i can tell), just the feed servo. (i haven't seen the continuous cooling fan run yet either, but i haven't run a full test with this feed issue).
As far as i can tell, i've hooked everything up alright (it was pre-built when i got it for the most part). Maybe a firmware setting i've missed?
many thanks for any help.