Post your own questions and topics to troubleshoot common problems with the gMax printer as well as similar printer designs.


Postby Izzy » Sat Jun 03, 2017 4:27 pm

When printing, machine goes through bed leveling and then extruder makes its way to the top and does not stop. When machine gets shut off to stop motor from burning out, an error message comes up that says, "THERMAL RUNAWAY, PRINTER HALTED, Please reset".

When I run all the machine's test parameters from the included SD card, and test print, everything is fine. Go to print a couple open-sourced files and it does this. Machine has had 4 successful prints up till now.

Any assistance would be appreciated.
These users thanked the author Izzy for the post (total 0):
Posts: 1
Joined: Sat Jun 03, 2017 4:18 pm
Has thanked: 0 time
Been thanked: 1 time

Return to Community Troubleshooting Forum

Who is online

Users browsing this forum: No registered users and 1 guest