So, I was trying to print R2's head this weekend.. and it had issues in the last 10% or so, obviously..
I was using the most recent version of Simplify 3D. The print did not slip or come loose from the bed.
I got almost identical results on a second print attempt. Then I tried printing only the top part of the model and got similar results, but not as dramatic. Later, I tried changing the settings a bit and re-calculating the G-code and it came out 98% correc, but with just a bit of twist and offset at the very top.
Any ideas what could cause this? Mechanical issue? Bad G-code? Other Slicer issue?
- These users thanked the author Magik0012 for the post (total 0):