I finally got my gMax all built and beginning calibration, so I figured I'd get a couple photos up here of the printer in it's current home. I'm attaching the photos to my post so we'll see if they show up in the thread or not.
Thankfully I only had to do some Y-Axis bed tightening and a little potentiometer adjusting in order to get my first part printed successfully, which was the little gCreate logo pictured. Unfortunately some of my other test prints haven't come out as nice as the keychain so I think I've got Slic3r configuring to do.
CalebC
Thankfully I only had to do some Y-Axis bed tightening and a little potentiometer adjusting in order to get my first part printed successfully, which was the little gCreate logo pictured. Unfortunately some of my other test prints haven't come out as nice as the keychain so I think I've got Slic3r configuring to do.
CalebC
Attachments
-
188.9 KB Views: 2,477
-
159.4 KB Views: 2,477
-
121.1 KB Views: 2,476