When an Endstop is Triggered the Printer Restarts

GORDON.LAPLANTE

Administrator
Staff member
#1
-If the printer shuts off after any of the endstops are triggered, that endstops may not plugged in correctly.

-Refer to the electronics wiring guide in the manual while checking the wires to ensure the red wire is in the correct side on each end of the wire. You may have to flip the connector and plug it back into the endstop.

-With the printer on, you can easily test each of the endstops by pushing the small metal lever, on the endstop, to see if a blue light comes on. If the printer restarts check the wires.