Z Probe out Simplify 3D

gCreate managed software & Firmware based troubleshooting forum.

Z Probe out Simplify 3D

Postby gCreate_Kyle » Mon Apr 18, 2016 1:28 pm

If you are printing from Simplify 3D through the machine control panel you may have noticed that you cannot home the Z axis with jog controls. The LCD screen will display this error.

Image
.
Instead to home the Z axis you need to send the auto bed leveling gcode command, G29, from the command line (found in the communication tab of Simplify 3D). You can only send G29 after you have homed the X and Y axis. Either using the jog controls or sending G28 X0 Y0.

Image
These users thanked the author gCreate_Kyle for the post (total 0):
R. Kyle Gress
gMax Technical Support
3D Printing/Electronics Enthusiast
User avatar
gCreate_Kyle
 
Posts: 169
Joined: Mon Feb 02, 2015 8:47 am
Location: Lancaster, Pennsylvania
Has thanked: 11 times
Been thanked: 18 times

Return to Software & Firmware Troubleshooting

Who is online

Users browsing this forum: No registered users and 1 guest