Menu
What's new

what setup do you wish you had bought from day 1

M

Mark

New Member
#1
#1
I am buying one in a week or so and was wondering what additional add ons I should get to go with it.
Lets assume i have a good budget to buy what i need from day 1.

Also what is the smallest nozzle size i can get with the e 3d v6 hotend? I would like to go smaller if possibble than the .5
and what type of nozzle am I looking for if i go to amazon to buy it..
 
oneaday

oneaday

Member
#2
#2
Mark said:
I am buying one in a week or so and was wondering what additional add ons I should get to go with it.
Lets assume i have a good budget to buy what i need from day 1.

Also what is the smallest nozzle size i can get with the e 3d v6 hotend? I would like to go smaller if possibble than the .5
and what type of nozzle am I looking for if i go to amazon to buy it..
Click to expand...

Heated build plate is a must and personally I'm more used to PEI as build plate surface, so I managed to get hold of a few 400x400mm sheets which I replaced my buildtak with.

Regarding nozzle sizes you can go down to 0.25mm I think!
I'm using 0.4mm Ruby Nozzles on all my printers but I'm printing ALOT of XT-CF filament which eat even stainless/hardened nozzles for breakfast...

If you're not printing abrasive filaments I like the Microswiss Nozzles!
 
You must log in or register to reply here.