Side profile pictures

#1
I'm part way thru putting my printer together and was hoping someone could help me out. I'm hopeful that someone could please post a few head on side profile pictures for me. I'm trying to assemble mine and I'm hoping for a better view that show the angles of how the frame pieces connect and, for example if pieces are touching or not.

Thanks,

Chris Russell
 
#2
viewtopic.php?f=8&t=83
That is how I assembled my printer (if it helps). I mounted the z-axis motors up top, then I wedged the small extrusion into the other extrusions to give it a strong bite. Once I wedged it in just right to make the z-axis motor level, then I tightened down the lower brackets on the inside instead of the outside.
I how this will help! :)