I would have bought the kit if it was in my budget to do so. I like the design and I like supporting small companies. Instead I have been slowly purchasing parts here and there. I ordered the ultra-lite 80/20 extrusions and only once they got here and I tried to tap them did I realize I should have ordered lite rather than ultra-lite. There is an extra challenge involved in tapping them because of the difference in the profile.
I've detailed the problem and solution I came up with in a blog post in case anyone else runs into the same issue (probably not, but I have time to kill while saving up for more parts): http://wudev.digitaltorque.com/2014/11/ ... -lite.html
I've detailed the problem and solution I came up with in a blog post in case anyone else runs into the same issue (probably not, but I have time to kill while saving up for more parts): http://wudev.digitaltorque.com/2014/11/ ... -lite.html