Holy cow! My first print looked like Alien 4!
After some searching over the internet it turned out I need to adjust Y-axis acceleration, it was too high. Found a way to do it on LCD screen, however, these settings get lost after I turn off the gMax.
Solution:
Use some g-codes to set parameters before printing starts.
To set x,y maximum accelerations use this line:
Mine was set to 9000 by default, after testing I ended up with 7000 for X and 3400 for Y.
See attached image for where to put this in Slicer. Remember to save your Slicer settings.
Enjoy!
After some searching over the internet it turned out I need to adjust Y-axis acceleration, it was too high. Found a way to do it on LCD screen, however, these settings get lost after I turn off the gMax.
Solution:
Use some g-codes to set parameters before printing starts.
To set x,y maximum accelerations use this line:
Code:
M201 X7000 Y3400 ; AmaxX = 7000, AmaxY = 3400
See attached image for where to put this in Slicer. Remember to save your Slicer settings.
Enjoy!
Attachments
-
127.4 KB Views: 1,791
-
153 KB Views: 1,791
-
58.9 KB Views: 1,791