I've noticed recently that the filament extruder drive gear isn't pushing filament down like it first did. The bearing that rolls with the gear isn't moving at the same rate and seems to be slipping.
I wedged a piece of paper between the spring that applies pressure between the gear and the bearing, however it only seems to help a little.
The bearing is also loose and seems to wobble around even though the nut is tight.
Any thoughts or experiences with this?
I wedged a piece of paper between the spring that applies pressure between the gear and the bearing, however it only seems to help a little.
The bearing is also loose and seems to wobble around even though the nut is tight.
Any thoughts or experiences with this?