Recent content by billiest

Thanks for the reply. I have had mine only a month. The two screws on the front plate were fairly loose too. You must be really nimble to be able to hold down the filament release spring, support the bottom and thread the filament. I tried, but I can't do it. I need a 3rd hand. I'm going to have...

Can someone please provide the configuration for CURA? I get multiple crashing with Slic3r and if I need supports, the little green bar just sits there. I have the XT+. When I tried copying Slic3r's config in where it seemed logical, the printer did not work. The gantry rose to mid level. I am...