Latest activity
-
NNodeX replied to the thread Printing to my Gmax via USB Linux.I have this Issue too. gMax 1.5+ Windows 10, Cura 3.1 I have a long USB-AB cable that, when plugged into the gMax, powers up the LCD...
-
gCreate_Joshua replied to the thread Z position unknown after autohoming.We have seen this happen in a couple machines, currently the only fix we have is to replace the electronics. I would recommend going... -
Rryandeleon1 posted the thread Z position unknown after autohoming in Software & Firmware Troubleshooting.I recently updated the firmware on my Gmax Gcreate 1.5+ to Marlin 1.1.8 Now after autohoming the printer the x and y positions read the...
-
Ccurry_jr left a message on gCreate_Joshua's profile.Is there any way to purchase the steel electronics case with the boards and latest updates already installed?
-
gCreate_Joshua liked jlgtx's post in the thread How to print non-PLA large-format objects on the gMax 1.5 XT+ (not for the faint of heart!).Thanks to Joshua at gCreate for this fix! One of the many potential side effects of a heated enclosure is that, due to the filament...
-
Bbdavis6653 updated their status.Fairly new to 3D printing, and am currently using Cura. I am trying to align two models for a dual extrusion. YouTube videos all show it...
-
Jjlgtx replied to the thread How to print non-PLA large-format objects on the gMax 1.5 XT+ (not for the faint of heart!).Thanks to Joshua at gCreate for this fix! One of the many potential side effects of a heated enclosure is that, due to the filament...
-
-
Kkilomonk replied to the thread Suggested UPS systems for power interruptions.@ Joshua Thanks again - I didn't realize I could control the zones with the Keenovo, since it doesn't route through the printer board...
-
Jjlgtx replied to the thread Suggested UPS systems for power interruptions.We use these. Unless power outages last more than a minute or so, there's really no need to plug the heated bed into the UPS.
-
Jjlgtx replied to the thread PETG Ooze Control Profile.I've had good success with a 4.5mm retraction distance at 30 mm/s. Seems to work well with both PETG and nGen.
-
Jjlgtx replied to the thread Rapid Y Axis Layer Shifting on large prints.gMax 1.5 XT+ http://forum.gcreate.com/index.php?threads/adjusting-stepper-drivers.1951/ gMax 1.5...
-
gCreate_Joshua replied to the thread Marlin 1.1.8 update issue extruder moves up to top rail and crashes and grinds during bed level script.We are trying to figure out why some printers are having issues with the latest firmware. The only solution we have found so far is to...
-
gCreate_Joshua replied to the thread Suggested UPS systems for power interruptions.It runs on 110v and pulls 800w when both zones are being used. 200w for the inner and 600w for the outer.
-
Kkilomonk replied to the thread Suggested UPS systems for power interruptions.I've ordered a UPS system. I'll probably put the Keenovo heater on another UPS - do you know the power output of that? I've looked...
-
gCreate_Joshua replied to the thread Suggested UPS systems for power interruptions.I am not sure if there is a benefit or not. Have not looked into that.
