Downloads
-
Cura 3.5 - Installing updated gMax Configuration FIles
Install updated gMax configuration files for Cura 3.5.1- gCreate
- Updated:
-
gMax 1.5+ Marlin 1.1.8 - Full Graphic Display Only
Marlin 1.1.8 firmware for the gMax 1.5+- gCreate
- Updated:
-
Cura 3.1 gMax 1.5+ Single and Dual Extruder Configuration Files
Cura 3.1 config files for the gMax- gCreate
- Updated:
Categories
-
-
Cura 3
-
-
-
-
-
-
gMax 2 - SD Card Files
190617
Files used for the gMax Printer found on the SD card
SD card files for your gMax printer
This manual is will familiarize you with your gMax printer when you first receive it.
This manual is will familiarize you with your gMax printer when you first receive it.
- Featured
Install updated gMax configuration files for Cura 3.5.1
Marlin 1.1.9 Firmware
SD card files for your gMax printer
- Featured
Marlin 1.1.8 firmware for the gMax 1.5+
- Featured
Cura 3.1 config files for the gMax
All the fan shrouds for the for the gMax 1.5+
BLTouch bracket for the gMax 1.5+
A new longer fan shroud and bltouch bracket for E3D Volcano
The firmware is used with gMax 1.5 XT DUAL Extruder printers
The firmware is used with gMax 1.5 XT SINGLE Extruder printers
gMax 1.5 DUAL Extruder Original LCD Screen
v 14.12.23
The firmware is used with DUAL Extruder gMax 1.5 printers
gMax 1.5 SINGLE Extruder Original LCD Screen
v 14.12.23
The firmware is used with SINGLE Extruder gMax 1.5 printers
This firmware is used with Single Extruder printers with Keyestudio electronics