Search results

I ran into this as well. Apparently it is not uncommon and the acrylic plate of the Replicator 2 also suffered from this. In my case it is just the back 3" that curls up. I went to my local hardware store and had them cut me a 18"x16" piece of 3/32" thick glass for $5-10 and clipped it in place...

Could be a few things. When I first setup my printer my filament was getting caught in the filament shaft as in this post. When this happened I over tightened and then over loosed the extruder lever and overvolted the extruder motor. Both of these things can cause what your seeing here. I...